STP: Root Bridge
Root Bridge Election Results What command can I use right now assuming both of these are Cisco switches to see what ports are.
Uncategorized
Spanning Tree Protocol (STP): The Beginning
Whether we’re layer 2 or Layer 3 and (that’s core switching at Layer 2 & routing at layer 3), we love redundancy. We’ve.
- by mani
- August 26, 2023
CCENT5
CDP Fundamentals
The Cisco Discovery Protocol (CDP) is super-helpful in the right circumstances. We’ve used it here and there to view info about directly connected.
- by mani
- June 20, 2023
CCENT5
Timestamps
To this point, I’ve disabled timestamps to make the various log messages easier to read. SO at the top of the config you.
- by mani
- June 18, 2023
CCENT4
Console Logging
The thing with logging is that the defaults are so good that you rarely adjust them! There are three main methods of accessing.
- by mani
- June 16, 2023
CCENT4
Fully Specified Static Routes
what I will do is remove the static route that we have on router 2 right now. And we want to see a.
- by mani
- June 9, 2023
CCENT4
Static Routes (Recursive and Directly Connected)
As we were suspecting, R2 cannot ping R4. They are on different subnets and version 6 is advanced but not that advanced! So.
- by mani
- June 4, 2023
CCENT3
Pinging IPv6 Addresses
We’re going to send some v6 pings from R2 to R3 over their shared subnet, then from R3 to R4 over their shared.
- by mani
- June 1, 2023